Parameter Transfer Command - SAGEMCOM Dr. Neuhaus ZDUE-GPRS-PLUS-VI User Manual

Configuration
R3 commands:

6.5.4 Parameter transfer command

Page 36 of 63
After this command is carried out, the data are initially stored in the volatile
memory of the ZDUE-GPRS-PLUS-VI. In order to transfer them to non-
volatile memory, the parameter transfer command W1P01() (see Section
6.5.4) must be executed.
1. Read class in partial blocks
Command format: <SOH>R3<STX>C<class>00000000( )<ETX><BCC>
Reply format: <STX>oooo(<data set>)[<EOT> | <ETX>]<BCC>
oooo
<data set>
Reading of class 79 with offset '0000', length '0000'
Example:
(reading of the operating parameters -> multiple partial
blocks required):
<CR><LF>
LS
/ABB61KGL923390R0003<CR><LF>
ZDUE
<ACK>061<CR><LF>
LS
<CR><LF>
LS
<SOH>P0<STX>(00000001)<ETX><BCC>
ZDUE
<SOH>P1<STX>(00000000)<ETX><BCC><CR><LF>
LS
<ACK>
ZDUE
<SOH>R3<STX>C7900000000()<ETX>,<CR><LF>
LS
<STX>0000(0800000000000000000899999999000000000
ZDUE
80000000000000000003PW00000)<EOT><BCC>
<ACK><CR><LF>
LS
<STX>0040(000000000151KGL923390R000300099015000000
ZDUE
21000040000000001150)<ETX><BCC>
In order for newly written parameters to be transferred at a specific point in
time, the following command is defined.
Executing this command causes the data of the previously transmitted
command "Write class" to be transferred to the non-volatile memory. The old
parameters remain active before this command is executed.
If the data are read before transfer by means of this command, the old
values will be output!
The transmission of a break deletes the data set temporarily in the device
via class write commands. This way faulty "Write class" commands can be
undone, so long as the W1 command defined here has not been
transmitted. Moreover, the temporary data are discarded by a disconnect or
the occurrence of an inactivity timeout.
Command format: <SOH>W1<STX>P01()(set password)<ETX><BCC>
= Offset (ASCII characters hexadecimal-
coded)
= data of the class (max. 64 ASCII
characters per partial block)
ZDUE-GPRS-PLUS-VI