Register Data Set In Gprs Mode; Communication Commands According To Din En 62056-21 - SAGEMCOM Dr. Neuhaus ZDUE-GPRS-PLUS-VI User Manual

GPRS Modes

7.4.4 Register data set in GPRS mode

General
Format of the error status

7.4.5 Communication commands according to DIN EN 62056-21

Parameterisation commands
Page 54 of 63
The register data set in GPRS mode is the same as in CSD mode. When
GPRS mode is activated, the IP address currently assigned to the device is
output in register 129-72:23.7.0 (see also Section 6.4)
Example: Accounting data of ZDUE-GPRS-PLUS-VI
1-1:F.F(00000005)
1-1:0.0.0(12345678)
1-1:0.2.0( 4.016)
1-1:0.9.1(135224)
1-1:0.9.2(110326)
1-1:C.91.0(Revision 01.002)
129-72:23.7.0(29.9.18.87)
!
T
The error status format is described in Section 6.4.2.
The ZDUE-GPRS-PLUS-VI in GPRS mode supports the same
communication commands as in CSD mode. There are also GPRS-specific
commands; these are listed in the following.
The three parameter classes 60, 61 and 82 additionally contained in the
ZDUE-GPRS-PLUS-VI for GPRS mode are configured according to the
parameterisation of the ZDUE-GPRS-PLUS-VI standard classes (see 6.5.3)
and saved to non-volatile memory in the device using the parameter transfer
command (see 6.5.4).
Error status
Power supply company identification
Firmware version of the ZDUE
Time (hhmmss)
Date (yymmdd)
Firmware version of GSM module
[own IP address]
ZDUE-GPRS-PLUS-VI