SAGEMCOM Dr. Neuhaus ZDUE-GPRS-PLUS-VI User Manual page 31

Class 79
Parameters
Daily watchdog
Time for daily watchdog
Interval for watchdog
Data format to control centre
String length of PIN
2
PIN
Operator Set Mode
Operator Delay Set
Cyclical query of the call
forwarding
1
In the reception path the ZDUE-GPRS-PLUS-VI evaluates all characters in the data format 7N. This
applies to Mode C monitoring and the addressing and communication with the ZDUE-GPRS-PLUS-VI
(address "99999999"). The set data format is used in the transmission path to the control centre
(regardless of the application interface). A consequence of this function is that it does not matter for
the parameterisation of the ZDUE-GPRS-PLUS-VI which data format is set at the control centre or in
the modem.
2
As long as the device has the status "PIN without errors", the PIN is changed accordingly both in the
device and on the SIM. The change is performed in service operation immediately after the transfer
command for parameters. In CSD operation the PIN is saved on the SIM and in the device
immediately after it is applied. The new PIN is saved in the device parameters only after the PIN has
been successfully changed on the SIM.
ZDUE-GPRS-PLUS-VI
Offset Len Values (ASCII)
'0'
103 1
'1'
'2100'
104 4
'0'
108 1
'1'
'2'
'3'
'4'
'5'
'0'
1
109 1
'1'
'0' .. '9'
110 1
('0' .. '9')
111 9
'0'
120 1
'1'
'4'
'15' .. '99'
121 2
'0'
123 1
'1'
Configuration
Description
activated, the device notices the
watchdog
no daily watchdog activated
The watchdog interval starts
daily at this time, relative to the
device time
every 24 hours
watchdog every 12 hours
watchdog every 6 hours
watchdog every 3 hours
watchdog every 2 hours
watchdog every 1 hour
Data format 7E1 (simulated)
Data format 8N1
Factory configuration: '4'
Factory configuration: '0000'
Automatic:
roaming permitted
Manual:
no roaming permitted!
Manual / Automatic:
Roaming permitted, but GSM
module is if necessary stopped
cyclically (Operator Set Delay)
in order to check into the home
network (GSM Net ID = first 5
digits of the IMSI).
Interval [in minutes] for module
request 'Operator Select', if the
parameterised and actual
operator are different.
Query of the call forwarding is
active
Query of the call forwarding is
passive
Page 31 of 63