Table of Contents
Advertisement
6.5.3 Parameterisation commands
W1 commands:
ZDUE-GPRS-PLUS-VI
Set password parameterised in the ZDUE-GPRS-PLUS-VI (default:
'00000000')
All of the passwords transmitted by the control centre must be the
same as the ones that were parameterised, otherwise the
communication will be terminated by the ZDUE-GPRS-PLUS-VI by
means of a break command. The request to transmit the password
(P0 operand) when programming mode is activated must be
answered with the password command (P1 command). The direct
transmission of a different VDEW command is not permitted.
The setting and reading of the parameters is performed via W1/R3
commands (ASCII-coded characters).
The class is used to select the individual parameter segments; the
command parameters 'offset' and 'length' can in general be used to
access individual parameter or parameter ranges. This is, however, not
supported by the ZDUE-GPRS-PLUS-VI; the classes can only be read or
written completely ('offset' and 'length' of the class equal to '0000').
1. Write class (completely)
Command format: <SOH>W1<STX>C<class>00000000(<data>)
(set password)<ETX><BCC>
Example:
Setting the parameters of the subgroup parameter class
79 to the following values:
Power supply company identification:
Device address:
Set password:
Control centre password act.:
Control centre password:
Communication ID:
Data format to meter:
Mode C monitoring:
Transfer timeout:
...
(The other parameters correspondingly)
/?99999999!<CR><LF>
LS
/ABB61KGL923390R0003<CR><LF>
ZDUE
<ACK>061<CR><LF>
LS
<SOH>P0<STX>(00000001)<ETX><BCC>
ZDUE
<SOH>P1<STX>(00000000)<ETX><BCC>
LS
<ACK>
ZDUE
<SOH>W1<STX>C7900000000(0812345678000000000874747
LS
4740000000008188718870000000000PW00000000000000151KG
L923390R00030119901600000021000140000000001150)(000000
00)<ETX><BCC>
<ACK>
ZDUE
'12345678'
'74747474'
'18871887'
'0'
'PW0'
'1KGL923390R0003'
'1'
'1'
'99'
Configuration
Page 35 of 63
Advertisement
Table of Contents
