SAGEMCOM Dr. Neuhaus ZDUE-GPRS-PLUS-VI User Manual page 40

Configuration
R3 commands:
Page 40 of 63
Write PIN
This command sets the PIN in the device to the new value. The PIN on the
card is not changed. Any PIN fault status that is present is cleared by this
command.
Command format: <SOH>W1<STX>S93(<PIN_Len><PIN>)(<set
password>) <ETX><BCC>
Response: <ACK>
The parameters have the following meaning here:
PIN_Len: Length of the PIN
PIN: PIN to be set
Set password: Set password parameterised in the ZDUE-GPRS-PLUS-VI.
This command is also permitted via the GSM interface.
Read parameter checksum
Command format: <SOH>R3<STX>S61( )<ETX><BCC>
Response: <STX>S61(cccc)<ETX><BCC>
cccc : Hex-coded 16-bit parameter checksum
This command is also permitted for the GSM interface.
Read firmware version of the ZDUE
Command format: <SOH>R3<STX>S63( )<ETX><BCC>
Reply (example): <STX>S63(ZDUE_PLUS_V_V4.017)<ETX><BCC>
This command is also permitted for the GSM interface.
Read firmware version of the GSM module
Command format: <SOH>R3<STX>S64( )<ETX><BCC>
Reply (example): <STX>S64(REVISION 01.002)<ETX><BCC>
This command is also permitted for the GSM interface.
Read version of the booter
Command format: <SOH>R3<STX>S96(14)<ETX><BCC>
Reply (example): <STX>S96(14)(<data>)<ETX><BCC>
This command is also permitted for the GSM interface.
ZDUE-GPRS-PLUS-VI