Table of Contents
Advertisement
Setup
3 Setup
To put the ZDUE-GPRS-PLUS-VI into operation, proceed as follows:
1. Read safety instructions at the beginning of this document
2. Insert SIM card
3. Connect meter(s)
4. Fit and connect antenna
5. Connect the ZDUE-GPRS-PLUS-VI to the power supply
6. If necessary, configure the ZDUE-GPRS-PLUS-VI (e.g. set date and time)
3.1 Inserting the SIM card
!
PIN
To insert the SIM card, proceed as follows:
Page 16 of 63
Warnung
Do not under any circumstances insert or remove the SIM card during
operation!
By factory default setting, the ZDUE-GPRS-PLUS-VI accepts SIM cards with
the PIN 0000
If your SIM card has a different PIN, you can change the setting of the
ZDUE-GPRS-PLUS-VI to the PIN of your SIM card in parameter class 79
(see chapter 3.6).
Alternatively, you can change the PIN using a mobile telephone.
With some network operators it is also possible to switch off the PIN query of
the SIM card. In this case it does not matter what the PIN is, because it is
ignored.
1. If the ZDUE-GPRS-PLUS-VI is connected to the power
SIM-
supply, disconnect all poles.
Card holder
2. Loosen the screw on the terminal cover and remove the
terminal cover.
3. Then remove the device cover.
4. Open the SIM card holder and slide the SIM card into
the flap of the holder. When the SIM card holder is
closed, the gold-plated contacts of the SIM card must
be in contact with the gold-plated contacts of the holder.
5. Close the flap of the SIM card holder and lock the flap
by carefully sliding leftwards. You will feel it latch into
place.
6. Re-attach the device cover and the terminal cover.
Page
3
16
17
18
17
19
ZDUE-GPRS-PLUS-VI
Advertisement
Table of Contents
