Service Commands - SAGEMCOM Dr. Neuhaus ZDUE-GPRS-PLUS-VI User Manual

6.5.7 Service commands

W1 commands:
ZDUE-GPRS-PLUS-VI
Example: Bit 8 (power return) is set in the status word.
/?99999999!<CR><LF>
LS
<CR><LF>
LS
/ABB61KGL923390R0003<CR><LF>
ZDUE
<ACK>061<CR><LF>
LS
<SOH>P0<STX>(00000001)<ETX><BCC>
ZDUE
<SOH>P1<STX>(00000000)<ETX><BCC><CR><LF>
LS
<ACK>
ZDUE
<SOH>R3<STX>S70()<ETX><BCC><CR><LF>
LS
<STX>S70(0000000100000000)<ETX><BCC>
ZDUE
<SOH>B0<ETX><BCC><CR><LF>
LS
Reset the status word:
Command format: <SOH>W1<STX>S70()<ETX><BCC>
Reset parameters to factory configuration:
This command is used to load the factory parameters. All customer-specific
settings are overwritten.
Command format: <SOH>W1<STX>S98( )<ETX><BCC>
The overwritten parameters are saved in non-volatile memory. The
device is then automatically rebooted.
This command is also permitted via the network (GSM interface,
GPRS).
This command is executed immediately after receipt (without
transmitting an additional break).
The manufacturer passwords and the manufacturer device addresses
are not reset by this command.
Remote reset of the ZDUE-GPRS-PLUS-VI
This command provokes a warm restart of the device. The command leads
to a watchdog reset followed by a restart of the firmware. No changes are
made to the parameters.
Command format: <SOH>W1<STX>S92( ) (<set password>)<ETX>
<BCC>
Response: <ACK>
This command is also permitted via the GSM interface
Configuration
Page 39 of 63