Ignore (Disable Breakpoint With Ignore Counts) [Icd Mini / Sim] - Epson S5U1C17001C Manual

ignore
(disable breakpoint with ignore counts)
Operation
Disables a specific break the number of times specified by a break hit count.
Format
ignore BreakNo Count
BreakNo: Break number (decimal)
Count: Number of break hits to be disabled (decimal or hexadecimal)
Usage example
(gdb) info breakpoints
Num Type
1 breakpoint
2 breakpoint
(gdb) ignore 2 2
Break number 2 is disabled twice.
(gdb) continue
Continuing.
Breakpoint 1, sub (k=1) at main.c:22
(gdb) continue
Continuing.
Breakpoint 1, sub (k=1) at main.c:22
(gdb) continue
Continuing.
Breakpoint 2, main () at main.c:14
Although the target program passes through the breakpoint twice as it is run twice (by continue) above, no break occurs. A
break occurs when running the program a third time because the breakpoint is reenabled.
Notes
 Break numbers are sequentially assigned to each breakpoint when set, beginning with 1. If you do not know the break
number of a breakpoint you wish to disable, use the info breakpoints command to confirm as in the example above.
 Count is used to count the number of times a specific break is hit, and not the number of times the target program is run.
The count is not decremented unless the program passes through a specified breakpoint.
 The ignore command cannot be used to collectively disable multiple breakpoints.
 Note that specifying a break number not set displays the "No breakpoint number N." message, with program execution
being aborted.
S5U1C17001C Manual
(Rev. 1.0)
Disp Enb Address
keep y 0x00c0003c
keep y 0x00c00030
Seiko Epson Corporation
What
in sub at main.c:22
in main at main.c:14
8 Debugger
[ICD Mini / SIM]
8-39