Billion BiPAC 7800VDP(O)X Dual-band Wireless-N VoIP ADSL2+ (VPN) Router PLEASE READ THE QUICK START GUIDE AND FOLLOW THE STEPS CAREFULLY. THIS QUICK START GUIDE WILL HELP YOU INSTALL THE DEVICE PROPERLY AND AVOID IMPROPER USAGE. IF YOU NEED MORE INFORMATION ON THIS SOFTWARE CONFIGURATION, PLEASE REFER TO THE USER MANUAL ON CD-ROM.
Quick Start Guide The Front LEDs Lit red when WAN port fails to get IP address; lit green when When the system is ready, WAN port gets IP address Lit green when wireless Lit green when the LED will be lit green; lit successfully.
Page 5
Quick Start Guide 1. Power Connection Plug the supplied power adapter to the wall jack and the other side to the router. Please note that the plug type may differ according to different country. 2. LAN Connection Connect the supplied Cat. 5e STP RJ-45 Ethernet cable to one of the Gigabit Ethernet ports, and the other side to the PC’s Ethernet interface.
Page 6
Billion BiPAC 7800VDP(O)X Dual-band Wireless-N VoIP ADSL2+ (VPN) Router 4. EWAN Connection Connect the supplied Cat. 5e STP RJ-45 Ethernet cable to the Ethernet WAN port (EWAN), and connect the other side to another alternative broadband device, such as Cable Modem, VDSL, Fibre Modem or PON optic lines.
Page 7
Quick Start Guide 7. Splitter/ Micro-filter Connection The Splitter / Micro-filter are important for ADSL installation, they help direct high-frequency signals to the ADSL modem & low frequency signals to the telephone or other analogue device to prevent inter-modulation distortion & get good speed/stable ADSL sync rate.
Page 8
Billion BiPAC 7800VDP(O)X Dual-band Wireless-N VoIP ADSL2+ (VPN) Router Please see the relevant sections of user manual for detailed instructions on how to configure your router. 1. None of the LEDs are on when you turn on the router. Check the connection between the adapter and the router. If the error persists, you may have a hardware problem.
Need help?
Do you have a question about the BiPAC 7800VDPX and is the answer not in the manual?
Questions and answers