Overview; Installation; Setup And Operation; Control Modes - SHOWTEC Stage Blinder 1 LED Manual

Stage Blinder 1 LED

Overview

01) LED pod
02) Primary fuse T3A, 250 V
03) Pro power connector IN (blue)
04) 3-pin DMX signal connector OUT
05) 3-pin DMX signal connector IN
06) Control panel
07) Cooling fan

Installation

Remove all packing materials from the Stage Blinder 1 LED. Check that all foam and plastic padding is
removed. Connect all cables.
Do not supply power before the whole system is set up and connected properly.
Always disconnect from electric mains power supply before cleaning or servicing.
Damages caused by non-observance are not subject to warranty.

Setup and Operation

Follow the directions below, as they pertain to your preferred operation mode.
Before plugging the unit in, always make sure that the power supply matches the product specification
voltage. Do not attempt to operate a 120 V specification product on 230 V power, or vice versa.

Control Modes

There are 2 control modes:

One Stage Blinder (Manual)

01) Fasten the effect light onto firm trussing. Leave at least 0,8 m on all sides for air circulation.
02) Always use a safety cable (order code 70140 / 70141).
03) Plug the power cord into the pro power IN connector of the device and connect to the mains.
04) When the Stage Blinder is not connected with a DMX cable, it functions as a stand-alone device.
See 5. Manual on page 15 for more information about manual mode.
Order code: 30784
● Manual
● DMX-512 (1CH, 2CH)
8
Fig. 01