Multiple Stage Blinders (Dmx Control) - SHOWTEC Stage Blinder 1 LED Manual

Stage Blinder 1 LED

Multiple Stage Blinders (DMX Control)

01) Fasten the effect light onto firm trussing. Leave at least 0,8 m on all sides for air circulation.
02) Always use a safety cable (order code 70140 / 70141).
03) Plug the power cord into the pro power IN connector of the device and connect to the mains.
04) Use a 3-pin XLR cable to connect the Stage Blinder and other devices.
05) Link the units as shown in Fig. 02. Connect a DMX signal cable from the first unit's DMX "out" socket to
the second unit's "in" socket. Repeat this process to link the second, third and fourth units.
06) Supply electric power: Plug the power cords into each unit's pro power socket, then plug the other
end of the power cord into proper electric power supply sockets, starting with the first unit. Do not
supply power before the whole system is set up and connected properly.
Multiple Stage Blinders DMX Setup
Order code: 30784
Note: Link all cables before connecting electric power
9
Fig. 02