Pause Time And Interdigit Time Selection; Mfr Timer - NEC Ranger AK Manual

•
Enter system programming mode
•
Press Line Key 1
•
Dial 0 4
•
Enter value
0 - 10 sec (*)
o
1 - 20 sec
o
2 - 30 sec
o
3 - 60 sec
o
•
Press MIC to store the data
•
Press SPKR to go back on line
Note: (*) indicates default value

1-05 : Pause Time and Interdigit Time Selection

Pause Time refers to the time in which no dial signals will be sent to the CO/PBX
line. This is the amount of time that the system will wait after a PBX access code or a
pause has been entered into a System or Station Speed Dial buffer. Interdigit time is
the amount of time that the system will wait between sending digits to the CO/PBX
line. The interdigit time selection pertains only to Dial Pulse lines.
•
Enter system programming mode
•
Press Line Key 1
•
Dial 0 5
•
Enter value for Pause time
0 - 1.0 sec
o
1 - 3.5 sec(*)
o
•
Enter value for Interdigit time
0 - 700msec @ 10pps / 550msec @ 20pps
o
1 - 800msec (*)
o
•
Press MIC to store the data
•
Press SPKR to go back on line
Note: (*) indicates default value

1-06 : MFR Timer

This Memory Block area is used to enter the time during which the receiver (MFR)
can receive DTMF signals from a Single Line Telephone. The receiver (MFR) can no
longer receive DTMF signals after the set time has elapsed. The timer begins after the
last digit is dialed.
•
Enter system programming mode
•
Press Line Key 1
17