Parameters Of Centrifugation; Accelerating/Decelerating - Changing Characteristics; Radius; Sample Density - Labnet C0336 User Manual

8 Parameters of centrifugation

ACCELERATION
DECELERATION
RADIUS [mm]
DENSITY (g/cm3)
TEMP. OFFSET (OC)
TH.CH. DELAY (min)
THERMAL CHAMBER
AUT. LID OPEN
START DELAY
8.1 Accelerating/decelerating – changing characteristics

8.2 Radius

8.3 Sample density

18 | Centrifuge user manual
• Press SET.
• With ▲▼◄► keys select PARAM.
• Press SET.
chosen acc. characteristic (0-the fastest, 9-the slowest)
chosen dec. characteristic (0-the fastest, 9-the slowest)
current rotor radius [mm]
sample density [g/cm3]
value of temperature correction
delay between set thermal chamber mode and start it
cooling of the chamber without centrifuging
opening cover after centrifuging automatically
starting delayed (after pressing START)
• ACCELERATION – 10 linear accelerating characteristics
assigned to every rotor (0 ÷ 9),
• DECELERATION – 10 linear decelerating characteristics
assigned to every rotor (0 ÷ 9).
• RADIUS [mm] - control of the radius of the rotor within the
range from R
min
rotor, see ––––– / ––––– (LIST OF ROTORS fold).
• To change the rotor radius select RADIUS [mm] with ▲▼ keys.
[MM].
• Press SET.
• Set demanded value by pressing ▲▼.
When radius is changed is activated,
the screen.
Reducing of the rotor radius (and the resulting change of displayed
RCF value) applies until switching off the power supply of the
centrifuge or setting the R
the program does not change this setting!).
• DENSITY (g/cm
To change the density (possible values 1,2÷9,9 g/cm
• Via ▲▼ keys select DENSITY (g/cm
• Press SET.
• Set demanded value by pressing ▲▼.
to R . Avalaible values depends on chosen
max
maximum radius once again (loading
max
) – default density is set to 1,2 g/cm
3
)
3
symbol is visible on
3
):
3