Programs With User Characteristics; Choosing Rotors - Labnet C0336 User Manual

To edit the deceleration characteristics, one should mark the section of characteristics with ▲▼ key (the whole
TIME+SPEED line will begin to blink; at this stage, it is only one section, with the number 1) and then press the
SET key. The device will proceed to setting the characteristics' section time (only the set TIME value is blinking).
With ▲▼ keys, one should set the required time value and press the SET key.
In order to compete the creation of the deceleration curve it is necessary for the speed of the last of
programmed sections of the curve to be equal = 0. Otherwise the curves wizard will not enable the end
of programming (it will be impossible to select the OK option).
After programming the section 1, there is a possibility to program the next section, number 2:
The maximum speed of the next section of deceleration characteristic is equal to the speed programmed
already of the previous section.
Repeated attempt to program already programmed sections of the acceleration characteristics will cause
beginning of programming of the whole deceleration characteristics once again (with settings of the
program loaded to edition).

6.6 Programs with user characteristics

Loading a modified program in the CURVES fold is signaled by the icon on the main screen:
It is not possible to change parameters (speed, rotor no. and others) during run, when program with user charac-
teristic is loaded. Changing these parameters is possible in PARAM/ ACCELERATION, PARAM/DECELERATION.

6.7 Choosing rotors

Loading a modified program in the CURVES fold is signaled by the icon on the main screen:
„2" SECTION
New section programming possible (the whole line 2 is blinking).
Programming as in the case of the section 1. To stop creating the
deceleration curve at the stage of two sections, it is necessary to
set the speed in section 2 to 0 and press the SET key.
„3" SECTION
New section programming possible (the whole line 3 is blinking).
Programming as in the case of the section 1. To stop creating the
deceleration curve at the stage of three sections, it is necessary
to set the speed in section 3 to 0 and press the SET key.
„4" SECTION
New section programming possible (the whole line 4 is blinking).
Programming as in the case of the section 1. If speed of the last
section=0, it is possible to save the created characteristics by
choosing the OK option with ▲▼ keys and pressing the SET key.
Icon signals that program with user acceleration/deceleration
characteristics are loaded.
• Press SET.
• With ▲▼◄► keys mark 11199 / ––––– zone.
• Press SET.
• With ▲▼ keys mark choose demanded rotor.
• Confirm by pressing SET.
Centrifuge user manual | 15