User Programs - Labnet C0336 User Manual

Exemplary change of TEMP setting:
Changing parameters during run
Detailed description of setting values (e.g. TIME).
• centrifuging time – 2 minutes 11 seconds
HOLD mode

6.5 User programs

Choosing program:
12 | Centrifuge user manual
0 0 : 0 2 : 11
[hh : mm : ss]
e.g.:
• Press SET (to enter edit mode).
• With ▲▼◄► keys mark TEMP fold (blinking).
• Press SET.
• Set demanded value by pressing ▲▼.
• Confirm set value by pressing SET.
• Leave edit mode by pressing BACK.
There is a possibility to change parameters: SPEED, RCF,
TIME, TEMP during centrifuging. Such modifications give in
currently running program. Modification during run is repre-
sented by PROG –– symbol.
• Press SET (to enter edit mode).
• With ▲▼◄► keys mark TIME fold (blinking).
• Press SET.
• Choose "hours", "minutes" or "seconds" by pressing ◄►, e.g.:
00:07:00 (00 - blinking).
• Set demanded value by pressing ▲▼.
• Repeat above two steps to set demanded time.
• Confirm set value by pressing SET.
• Leave edit mode by pressing BACK.
set value
current value (most significant digits)
continuous operation mode
• To run centrifuging in HOLD mode set 00:00:00 time.
• To end centrifuging in HOLD mode press STOP.
After switching centrifuge on, program that was used in previous
session is being loaded.
Modification during run is represented by PROG – – symbol.