Residual Risk; Operating; Centrifuge Description; Centrifuge Overview - Labnet C0336 User Manual

ROTORS
• It is not allowed to use the rotors and round carriers with signs of corrosion or other mechanical
defects.
• It is not allowed to centrifuge highly corrosive substances which may cause material impairment and
lower mechanical properties of rotor and round carriers.
• It isn't allowed to use rotors and accessories not admitted by the manufacturer. Let to use commercial
glass and plastic test tubes, which are destined to centrifuging in this laboratory centrifuge. One
should absolutely not use poor quality elements. Cracking of glass vessels and test tubes could
result in dangerous vibration of the centrifuge.
• It is not allowed to carry out centrifugation with the rotor caps taken off or not driven tight.

4.7 Residual risk

The centrifuge is built according to the state-of-the-art and the recognized safety regulations.
Nevertheless, still remain some level of residual risk due to improper operation and malfunctions. It is possible to
decrease residual risk by strictly applying user manual conditions and correcting malfunction which could threaten
safety, immediately.

5 Operating

5.1 Centrifuge description

New generation of LABNET INTERNATIONAL laboratory centrifuges is provided with state-of-the-art micropro-
cessor control systems, very durable and quiet asynchronous brushless motors and accessories consistent with
requirements of the present-day user.

5.2 Centrifuge overview

Fig.2. Right side of centrifuge
Fig.3. Assembly of angle rotor
1. Motor axle
2. Rotor
3. Rotor lid
4. Complete clamp

5.3 Construction

The centrifuge has rigid self-supporting structure. Housing was made of sheet aluminum, back made of steel
sheet. Front and cover was made of ABS type plastic. Cover is fixed on steel axles of hinges and from the front it
6 | Centrifuge user manual
Fig.1. General view
6
5
4
3
2
1
4
3
2
1
1. Power switch
2. USB
3. Control panel
4. Point of emergency lid opening
5. Lid
6. Inspection glass
Fig.4. Mains socket back
of the centrifuge
1
2
1. Main socket
2. Fuse socket