Table of Contents
Advertisement
3-2 Jumper Settings
All manuals and user guides at all-guides.com
JCMOS:
To CMOS Clear data, please follow the steps below.
1. Turn off the system.
2. Change the jumper from “1-2” to “2-3” position for
a few seconds.
3. Replace the jumper on to the “1-2” position.
4. Turn on the system and hold down the <Del> key
to enter BIOS setup.
JCK1/
JCK2:
If you change JCK1 and JCK2 back to default settings,
you must use the Clear CMOS function, or else the
system will not boot-up.
Note: Overclocking may cause system instability and
are not guaranteed to provide better system
performance.
Settings:
1-2: Normal (Default)
2-3: Clear CMOS
1
JCK1 JCK2 Settings:
1-2
1-2
1
2-3
1-2
2-3
2-3
1-2
2-3
CAUTION !
Installation
By BIOS (Default)
133MHz
166MHz
200MHz
Page 3-5
Advertisement
Table of Contents
