Jumpers And Switches; At/Atx Mode; Table 22: At/Atx Mode Jumper Settings; Figure 28: At/Atx Mode Jumper - VIA Technologies EPIA-M860-12E User Manual

3. Jumpers and Switches

3.1. AT/ATX Mode

For the ATX version of the EPIA-M860, there is a jumper that can enable the mainboard to switch between two power
modes: AT and ATX. The jumper is labeled as "J10". The jumper settings are shown below.

Figure 28: AT/ATX mode jumper

Table 22: AT/ATX mode jumper settings

The recommended setting of the jumper is the ATX mode. For the DC version of the board, always keep the jumper on
the ATX mode setting.
Setting Pin 1 Pin 2
ATX mode On On
AT mode Off On
EPIA-M860 User Manual
Pin 3
Off
On
27