Table of Contents
Advertisement
MOD TW100
The UC IR infrared remote gives you control of various functions (See below). To control the fixture
you must aim the remote at the front of the fixture and be no more than 30 feet away. To use the ADJ
UC IR you must first activate the fixtures infrared sensor, to activate the sensor please see the instructions
on page 21.
The Airstream IR remote transmitter plugs into the headphone jack of your iOS phone or tablet. To
control your IR fixture you must raise the volume to the maximum on your iOS phone or tablet and
aim the transmitter at the fixture sensor and be no more than 15 feet away. The app is a free download
from the app store for your iOS phone or tablet. The app comes with 3 pages of control depending on
the fixture you are using. Please see below for IR functions including the corresponding app page.
Works with App page 1
STAND BY - Pressing this button will blackout the fixture. Press the button again to return to the
initial state.
FULL ON - Press this button down to fully light up the unit. Press any button to exit this mode..
FADE/GOBO - Press this button to switch between Color Change Mode, Color Fade Mode, and
Auto Run Mode. Use buttons 1-9 to select your desired show. Press this button twice for show 10.
Press button "1" twice for show 11.
UPDATE WITH SOFTWARE VERSION 1.01: This button can activate color change mode, color
fade mode, or combination color change and fade mode (Auto Run). Each press of the button will switch
through the 3 different modes. Use the numeral buttons 1-9 to select the program number within your
desired mode. Use the dimmer buttons to adjust the output intensity. Note: Running speed is not ad-
justable using the IR control functions.
Example: In color change mode (Jump Run), press the numeral buttons "1+3" to run color change program
"13". In color fade mode (Fade Run), press the numeral button "7" to run color fade program "7".
Note: Color change and fade combination (Auto Run) mode has only one program.
"DIMMER +" and "DIMMER -" - Use these buttons to adjust the output intensity when either color
macro mode, color change mode, color fade mode is active.
STROBE - Press this button to activate strobing. Use buttons 1-4 to adjust the strobe speed. "1"
being the slowest, "4" being the fastest. Press this button again to stop strobing.
COLOR - Press this button to activate color macro mode. Use the numeral buttons 1-9 to select your
desired color. Use the dimmer buttons to adjust the output intensity.
Example: Press the numeral buttons "1+3" to activate color macro "13".
ADJ Products, LLC - www.adj.com - MOD TW100 User Manual Page 22
Full ON
Fade/Gobo
Strobe
Color
1
4
7
SoundOn
Show 0
ADJ UC IR/ Airstream IR Control
Stand by
2
3
5
6
8
9
SoundO
Advertisement
Table of Contents
