Table of Contents
Advertisement
MOD TW100
With this feature you can connect the fixtures to one another using the powerCON input and
output sockets. The maximum that can be connected is 5 fixtures @ 120V and 9 fixtures @
240V. After the maximum connected fixtures you will need to use a new power outlet.
NOTE: USE CAUTION WHEN POWER LINKING OTHER FIXTURES TO THE MOD TW100 AS
THE POWER CONSUMPTION OF OTHER LIGHTING FIXTURES WILL VARY!
MOD TW100
Listed below are a few common problems the user may encounter, with solutions.
Unit not responding to DMX:
1. Check that the DMX cables are connected properly and are wired correctly (pin 3 is "hot"; on
some other DMX devices pin 2 may be 'hot'). Also, check that all cables are connected to the right
connectors; it does matter which way the inputs and outputs are connected.
Unit does not respond to sound:
1. Quiet or high pitched sounds will not activate the unit.
2. Make sure that Sound Active mode is activated.
MOD TW100
Due to fog residue, smoke, and dust cleaning the internal and external optical lenses must be car-
ried out periodically to optimize light output.
1. Use normal glass cleaner and a soft cloth to wipe down the outside casing.
2. Clean the external optics with glass cleaner and a soft cloth every 20 days.
3. Always be sure to dry all parts completely before plugging the unit back in.
Cleaning frequency depends on the environment in which the fixture operates (i.e. smoke, fog residue,
dust, dew).
ADJ Products, LLC - www.adj.com - MOD TW100 User Manual Page 26
Multiple Unit Power Linking
Trouble Shooting
Cleaning
Advertisement
Table of Contents
