SSANGYONG KYRON 2007.04 Manual page 682

2) Check
1. Visual Check Check the components for
wear and crack and replace if needed.
2. Outer diameter of spider journal.
Specified value
Limit
3. Clearance between spider journal and
bearing.
Specified value
Limit
4. Run-out of propeller shaft Set up the dial
gauge on the center point of propeller
shaft and measure the run-out. If the run-
out is out of the specified range, correct it
with press or replace it with new one.
Limit
5. Starting torque of universal joint.
Specified value
6. Major causes of vibration
- Balance weights missing
- Excessive run-out of propeller shaf
- When using the general bolts
- Excessive wear of universal joint
- Stuck in sleeve joint
-
Vibration is mainly caused by the angle
changes in front and rear universal joint.
It normally occurs when the vehicle
speed is 60 ~ 100 km/h.
10-13
3310-00
17.893 mm
17.910 mm
0.03 ~ 0.098 mm
0.25 mm
0.4 mm
3 ~ 8 kg.cm
PROPELLER SHAFT
KYRON 2007.04