SSANGYONG KYRON 2007.04 Manual page 498

2) POWER SEAT
▶ Seat Position Control
- The position sensor senses the changes of motor in the seat.
- The seat position is stored by the memory order of position switch.
- The stored seat position is recalled by the recall order of position switch.
- The manual adjustment of seat positions takes priority over the memory and recall orders.
▶ Motor Drive Control
- In the case of the automatic control, each motor drive is delayed for 100 msec to prevent
the irruptive current frombeing overlapped. The priorities are as follows.
Seat sliding → Seatback reclining → Seat cushion height adjusting (front) → Seat
cushion height adjusting (rear)
- Continuous motor driving timeSeat sliding: 16 seconds, Seatback reclining : 50 seconds,
Cushion height adjusting : 6 seconds
- Reverse controlWhen reversing the control motor, the motor starts to rotate in the
opposite direction 100 msec after the forwarddriving is completed.
- The motor doesn't operate if the difference between the stored position and the current
position is out of thespecified range
· Sliding : 12 edges (6 pulses)
Cushion height : 6 edges (3 pulses)
·
Reclining : 100 mV
·
04-11
7410-13
SPWM
KYRON 2007.04