Display Of Operator Screen - Mitsubishi LE-40MTB-E Instruction Manual

5.4 Display of operator screen

The usual operations (setting operations) are performed on the following screen.
Automatic
Operation
Mode selected
Tension set
T N S N . S E T M E N U #
S E T →
T N S N . S E T
Stall set
S T A L L S E T M E N U #
S E T →
S T A L L S E T
Manual
Operation
Mode selected
Manual setting
M A N U . S E T M E N U #
S E T →
M A N U . S E T
S E T →
M A N U . S E T
Total tension monitor
T N S N . M N T .
T A R G E T
T N S N . M N T .
T A R G E T
Tension monitor left and right
T N S N . M N T . L E F T
R I G H T →
T N S N . M N T . L E F T
R I G H T → # # # . # × 10 N
The values ara changed and valid by the pulser dial.
Note that in the screen shown MENU1 ~ MENU 7, the values changed will not be protected against power
supply interruption. To protect the set values against power supply interruption, press the [ENTER] key twice
to register the values in the menu table.
M N T . →
M N T . → →
# # # # N
S E T → # # # . # × 10 N →
# # # % T N S N .
S E T → O U T P U T →
# # # %
When new reel and taper
functions are in use .
# # # % T N S N .
# # # % T N S N .
S E T →
# # # %
→ →
# # # # N
→ # # # . # × 10 N →
→
# # # # N
T A R G E T →
→ # # # . # × 10 N # # # # N
T A R G E T → # # # . # × 10 N
When use reel diameter input ,
Password
connected to LE -40MD,
screen
"LINK" is selected in "TPR.DIA" screen.
16
• The bar graph in the upper right corner always
indicates the detected tension (%). The "100%"
indication corresponds to the full -scale tension.
→
# # # # N
# # # %
→
# # # # N
→ # # # . # × 10 N
O U T P U T →
# # # %
# # # # N
• This displays the set
tension.
• The unit of tension such
as "×10N" and " N " and
the position of the
decimal point are
determined depending on
the parameter setting .
• This is to enter the stall
values .
Refer to pages 13 and 14
for more about the stall
functions.
• Sets the operation torque
for the manual operation .
Refer to page 15 for the
guideline of setting .
• Displays the tension or
the output by the
tension/output select
switch on the panel.
• When carrying out the
taper control , the taper
ratio is taken into the
"target (target tension )"
value.
• This displays the left and
right tension
measurement . This
allows to check whether
the tension in the material
is balanced.