Pedal Fx; Foot Volume - Boss GT-1000 Parameter Manual

TERA ECHO
Parameter Value Explanation
Selects the mode of the effect sound.
MONO The L and R channels will both output the same
sound.
MODE
STEREO 1 The R channel outputs the direct sound, and the
L channel outputs the effect sound.
STEREO2 The effect is applied separately to the L and R
channels.
SPREAD TIME
0–100 Adjusts the length of the effect sound.
FEEDBACK
0–100 Adjusts the decay of the effect sound.
EFFECT LEVEL
0–100 Adjusts the volume of the effect sound.
TONE
-50–+50 Adjusts the tone.
DIRECT LEVEL
0–100 Adjusts the volume of the direct sound.
The effect sound is held when you turn this on.
TRIGGER OFF, ON

PEDAL FX

You can control the wah effect or get a pitch bend effect in real time
by adjusting the GT-1000's expression pedal or the expression pedal
connected to the CTL 4, 5/EXP 2 jack or CTL 6, 7/EXP 3 jack.
Parameter Value Explanation
ON/OFF OFF, ON Turns this effect on/off.
This lets you use the pedal to get a pitch bend
effect.
PEDAL BEND
* Because of the need to analyze the pitch,
TYPE
You can control the wah effect in real time by
adjusting the GT-1000's expression pedal or the
WAH
expression pedal connected to the CTL 4, 5/EXP 2
jack or CTL 6, 7/EXP 3 jack.
PEDAL BEND
Parameter Value
PITCH -24–+24
PEDAL
0–100
POSITION
EFFECT
0–100
LEVEL
DIRECT MIX 0–100
5 Patches are written with the parameter set
to Off.
chords (two or more sounds played
simultaneously) cannot be played.
Explanation
This sets the pitch at the point where the EXP
Pedal is all the way down.
Adjusts the pedal position for pedal bend.
This parameter is used after it's been
assigned to an expression pedal or similar
controller.
Adjusts the volume of the pitch bend sound.
Adjusts the volume of the direct sound.
WAH
Parameter Value
Selects the type of wah.
CRY WAH
VO WAH
FAT WAH
LIGHT WAH
WAH TYPE
7STRING WAH
RESO WAH
BASS WAH
PEDAL
0–100
POSITION
PEDAL MIN 0–100
PEDAL MAX
0–100
EFFECT LEVEL 0–100
DIRECT MIX 0–100

FOOT VOLUME

This is a volume control effect.
Normally, this is controlled with the GT-1000's expression pedal or the
expression pedal connected to the CTL 4, 5/EXP 2 jack or CTL 6, 7/EXP
3 jack.
Parameter Value
VOLUME MIN 0–100
VOLUME MAX 0–100
SLOW1,
VOLUME SLOW2,
CURVE NORMAL,
FAST
PEDAL
0–100
POSITION
Explanation
This models the sound of the CRY BABY wah
pedal popular in the '70s.
This models the sound of the VOX V846.
This is a wah sound featuring a bold tone.
This wah has a refined sound with no unusual
characteristics.
This expanded wah features a variable range
compatible with seven-string and baritone
guitars.
This completely original effect offers
enhancements on the characteristic
resonances produced by analog synth filters.
This wah has been specially adapted for use in
the bass registers.
Inclusion of the low-frequency range in the
wah sound produces a robust wah effect, with
no dilution of the sound.
Adjusts the position of the wah pedal.
* This parameter is used after it's been
assigned to an expression pedal or similar
controller.
Selects the tone produced when the heel of
the EXP Pedal is depressed.
Selects the tone produced when the toe of the
EXP Pedal is depressed.
Adjusts the volume of the effect sound.
Adjusts the volume of the direct sound.
Explanation
Sets the volume when the heel of the EXP Pedal
is depressed.
Selects the volume when the toe of the EXP
Pedal is depressed.
You can select how the actual volume changes
relative to the amount the pedal is pressed.
Volume
When the pedal is When the pedal is
fully raised fully advanced
Adjusts the volume.
Effect
23