Basic Operation; Basic Procedure For Effect Editing; Effect Placement - Boss GT-1000 Parameter Manual

Basic Operation

Basic Procedure for Effect Editing

The edit screens show the block configuration (effect chain) of all
effects provided by the GT-1000, as well as the output and send/
return. You can edit from this effect chain display by selecting the
block that you want to edit.
1
Press the [EFFECT] button.
The edit screen (effect chain) appears.
2
Turn knob [6] to select the block that you want to
edit.
The selected block is enclosed by a thick frame.
* By pressing knob [6] you can turn the selected effect on/off.
Effects that are off are shown in gray.
ON OFF
3
Use knobs [1]–[5] to adjust the parameters that are
shown below the screen.
Use the PAGE [ K ] [ J ] buttons to switch between the parameters
that you want to edit. The current page is indicated in the lower
center of the screen.
* The number of parameters and pages differs depending on the
effect.
Editing while viewing all parameters
From the edit screen, you can long-press knob [6] to see a list of all
parameters of the selected block. You can edit the parameters from
this list.
1
Turn knobs [1]–[6] to edit the value of the
parameters shown in the screen.
Use the PAGE [ K ] [ J ] buttons to switch between lists of
parameters.

Effect Placement

By moving blocks such as effects, output, and send/return, you can
freely change the order in which the effects are placed, or arrange
them in parallel.
Changing the placement of effects etc.
1
Press the [EFFECT] button.
The effect chain is shown.
2
Use knob [6] to select the block that you want to
move.
3
While pressing knob [6], turn it left or right.
The selected block moves left or right.
Use the PAGE [ K ] [ J ]
buttons to switch
3