Table of Contents
Advertisement
Hi‐T
Centralized controller
3.6.5.1
USER MENU – KEYBOARD SETUP
To access the user menu you have to set the user password (modifiable): 0.
From here you can:
•
Set the date and the time by pressing on "Clock" (it appears the screen shown in Figure 22);
•
Set the language by pressing on "Language";
•
Access to the setup of the keyboard, pressing on "Parameters".
It is possible to change the setup of the keyboard according to the parameters shown in the following table:
N.
PARAMETERS NAME
1/3 User password
2/3 Idle Backlight intensity
3/3 Screensaver unlock Psw Numb
To change the value of a parameter:
•
entered in "Parameters", use the up and down arrows to scroll through the pages of the parameters, until you find the
desired parameter;
•
press on the currently set value;
•
the present value turns red to indicate that it can be changed by using the up and down arrows;
•
select the desired value and press the confirmation tick.
•
Note: If you press outside the confirmation area, it returns again the previously value.
3.6.5.2
SERVICE MENU
To access the menu, you must set the service password.
From here you can:
• configure the network, by pushing on "Address configuration";
• configure zones, by pushing on "Area Configuration";
• access to service's parameters Chiller, Hi‐T and Fan coil, pressing on "Parameters";
• access to the alarm history, by pushing on "Alarm list".
The screens shown are as follows:
1. Address configuration
1.1. Addresses assigns
1.2. Scan network
2. Area configuration
2.1. Zone 01
2.2. Zone 02
2.3. Zone xx
3. Maintenance parameters
3.1. Chiller
3.1.1. Chiller 01
Figure 22. Date and time page settings.
UNIT
DEFAULT VALUE MINIMUM VALUE MAXIMUM VALUE
Numb
%
Table 3. User's parameters menu (keyboard setup).
0
0
5
0
0
0
999
100
999
20
Advertisement
Table of Contents
