Table of Contents
Advertisement
Hi‐T
Centralized controller
3.5 SECOND MAIN PAGE
From the home page, touching the arrow icon to navigate to the next screen, you go to a second screen showing all of the
detections carried out by the temperature sensors and humidity sensors in the system.
Referring to the figure above:
•
Field 1 indicates the zone to which you are referring ; applying pressure on it, you switch to the next zone.
•
Field 2 indicates the fan coil which is referenced within the zone selected from the field 1; pressing on it the index of the
selected zone progresses in a cyclic manner, giving away all the fan coil units in the area. For each fan coil is shown the
detected air temperature. These indications appear only if there are fan coils configured in the system.
•
Field 3 indicates the chiller which it refers; by pressing on it, you progress to the next chiller in the network. For each chiller
shown, you see the readings on the temperature of the water inlet and outlet of the chiller and on the air temperature
measured by the probes on board.
•
Field 4 shows the ambient temperature and the relative humidity measured by the sensors integrated in the Hi‐T panel.
•
Field 5 indicates the presence of the solar system; then the indication on the temperature of the solar panels is shown.
These indications appear only if in the system is configured a solar panel.
•
Field 6 shows the enabling of the production of domestic hot water related to the chiller selected from field 3 . It also
indicates the temperature of the domestic hot water production.
•
Field 7 indicates the presence of a storage tank connected to the chiller selected from field 3. It also indicates the
temperature of the domestic hot water production.
•
Field 8 indicates the presence of radiant floor; this field is connected to the enabling of the function of double set ‐point.
In the case of probes in error or not properly configured and connected , it appears the indication of error.
NOTE: The presence of accumulation and the sanitary mode are here referred to the fact that in the network is present a heat pump
in which the sanitary mode is enabled.
1
4
3
Figure 15. Second Main page.
5
6
7
8
2
16
Advertisement
Table of Contents
