Emptying System Type A; Emptying System Type B - Kessel EasyClean free NS 2 Installation, Operation And Maintenance Manual
Hide thumbs
Also See for EasyClean free NS 2:
Table of Contents
Advertisement
4.3
Emptying system type A
•
Carefully loosen the clamping ring and remove the inspection cover (Caution! Risk of injury)
•
Move the suction spout of the disposal vehicle past the feed or drain part and empty / extract the contents of
the system tank
function. )
•
When the system tank is about 1 third empty, open the hot water inlet.
•
When the system tank is completely empty, remove the extraction hose from the disposal vehicle and switch
the hot water supply off.
•
Clean the system tank thoroughly (spray down), dispose of grease residues.
If the system tank is not refilled with water after emptying (top of outlet structure of bottom part), grease and
suspended solids can flow freely into the sewage system.
•
Fill the system tank up to the system overflow.
•
Clean and check cover seal (renew if necessary).
•
Carefully close the inspection cover with clamping ring. (Caution! Risk of injury)
4.4
Emptying system type B
•
Carefully loosen the clamping ring and remove the inspection cover (Caution! Risk of injury)
•
Connect the extraction hose of the disposal vehicle to the direct disposal pipe.
•
Empty system tank (extraction).
•
When the system tank is about 1 third empty, open the hot water inlet.
•
When the system tank is completely empty, remove the extraction hose from the disposal vehicle and switch
the hot water supply off.
•
Clean the system tank thoroughly (spray down), dispose of grease residues.
If the system tank is not refilled with water after emptying (top of outlet structure of bottom part), grease and
suspended solids can flow freely into the sewage system.
•
Fill the system tank up to the system overflow.
•
Clean and check cover seal (renew if necessary).
•
Carefully close the inspection cover with clamping ring. (Caution! Risk of injury)
010-916_SON_EN
Carrying out emptying
(Caution! Damage to the installed components leads to problems with the separating
14 / 18
2018/01
Advertisement
Table of Contents
