Quick Start: Commissioning, Software - MICRO-EPSILON scanCONTROL 2900 Assembly Instructions Manual

8.

Quick Start: Commissioning, Software

Install the software.
Mount the sensor according to the installation instructions.
Connect the sensor to the PC via the Ethernet cable.
Connect the sensor to display or monitoring units.
Connect the sensor to the power supply.
The connectors for Ethernet and the multifunction port are fitted with an Escha screw
connector.
Loosen the screws before you remove the connector from the socket.
Connect the shield of the power supply cable to the PE protective earth conduc-
tor of the main power supply. Close unused connection plugs with the provided
protective caps. Switch on the power supply (24 VDC).
i
Only connect the sensor to the peripheral equipment, if it is disconnected from
the power supply, i.e. only when the operating voltage is switched off. The sen-
sor needs a warm-up time of typically 20 minutes for high precision measure-
ments.
Please wait until the scanCONTROL device is recognized by the PC.
This may take a few seconds.
Now you can operate the scanCONTROL measurement system with the scanCON-
TROL software packages.
i
Operating a scanCONTROL sensor via Ethernet may require a modification of
the IP settings of the PC/sensor or a modification of the firewall settings, see
Chap. 5.2.5 of instruction manual.
Please insert the scanCONTROL Demo
CD in the CD-ROM device. Follow the
dialog through the installation process.
A. Reading of installation help
B. Installation of software
C. Further informations in the online
documentation