Table of Contents
Advertisement
70. DHCPv6: client and relay
71. ICMPv6
72. IPv6 Path MTU
73. NDP: host and router
74. IPv6 address stateless auto-configuration: host and router
75. IPv6 static route
76. Guest VLAN
77. Password encryption
78. User access right
79. PPPoE IA and option 82
80. ECMP
81. 384 ACL
82. 64 Policy route
83. Configurable ARP learning mode
84. Recovery mechanism for error-disabled port/reason.
85. CPU protection
86. sFlow
87. Private VLAN
88. Authorization on console
89. ARP Freeze
90. Static ARP setting
91. MAC pinning
92. Interface related trap can be enable/disable by port
93. Multiple default route
94. 802.1AB LLDP-MED
95. DHCP option 82 profile
96. Remote port mirroring
97. ZyXEL new private MIB
98. Dual image
99. Dying gasp
100. DHCP Option82 per VLAN and per Port
101. Intrusion lock
Known Issue:
1. A filtering rule with discard source action will always filter packets regardless of source
MAC or destination MAC.
2. When using three different spanning tree protocols (RSTP+MSTP+MRSTP) on the whole
system, the system will loop.
3. Port movement of IPv6 address is not supported currently.
4. When RSTP is enabled with ring topology, LACP can't be activated at the same ports.
5. Config private VLAN with follow features are not recommend
VLAN stacking
VLAN mapping
Bug fix:
1. [MIB-zyxelIpsg] When using SilverCreek to test the zyArpFreeze (OID:
1.3.6.1.4.1.890.1.15.3.33.1.1), DUT will crash.?
2. [Static Route] Send port-pair L3 traffic via static route, only one direction can forward.
Please refer to the attachment file.?
3. [Mirror] In mirror test, the leraned packet will broadcast to other ports. The behavior is
abnormal. Execute MAC-Flush, DUT will be ok. Please refer to the attachment file.?
4. [Flow Control] Flow control could not load blance cross unit?
5. [syslog] when testing on enable/disable switch type trap-ping, DUT was crash and
automatically restarted itself?
6. [MIB-transmission] The dot3StatsDeferredTransmissions (OID: 1.3.6.1.2.1.10.7.2.1.7)
counter can't be added.?
7. [syslog] after system voltage value was back from error to normal, a recovered log should
be display when show logging (ex: System voltage has recovered to normal state)?
Advertisement
Table of Contents
