Table of Contents
Advertisement
70. DHCPv6: client and relay
71. ICMPv6
72. IPv6 Path MTU
73. NDP: host and router
74. IPv6 address stateless auto-configuration: host and router
75. IPv6 static route
76. Guest VLAN
77. Password encryption
78. User access right
79. PPPoE IA and option 82
80. ECMP
81. 384 ACL
82. 64 Policy route
83. Configurable ARP learning mode
84. Recovery mechanism for error-disabled port/reason.
85. CPU protection
86. sFlow
87. Private VLAN
88. Authorization on console
89. ARP Freeze
90. Static ARP setting
91. MAC pinning
92. Interface related trap can be enable/disable by port
93. Multiple default route
94. 802.1AB LLDP-MED
95. DHCP option 82 profile
96. Remote port mirroring
97. ZyXEL new private MIB
98. Dual image
99. Dying gasp
100. DHCP Option82 per VLAN and per Port
101. Intrusion lock
102. DAC 10G
Known Issue:
1. A filtering rule with discard source action will always filter packets regardless of source
MAC or destination MAC.
2. When using three different spanning tree protocols (RSTP+MSTP+MRSTP) on the whole
system, the system will loop.
3. Port movement of IPv6 address is not supported currently.
4. When RSTP is enabled with ring topology, LACP can't be activated at the same ports.
5. Configuring private VLAN with follow features are not recommend
1.
VLAN stacking
2.
VLAN mapping
3.
Remote port mirroring
6. Configuring port isolation with remote port mirroring is not recommend
7. When using SilverCreek to test the zyxelManagement (OID: 1.3.6.1.4.1.890.1.15.3.49),
CLI will pop error message and restore configuration will cost much time.
The zyxelVlanCounterStatus (OID: 1.3.6.1.4.1.890.1.15.3.87.2) counters can't be
8.
added.
It only create 8 static route entry. When create over 8 entry, CLI will pop error
9.
messages.
10. In default configure, send port pair traffics in unit 1, then send the learned packets in unit 2,
the learned packets will broadcast to other ports.
11. Flow control could not load balance cross unit.
12. after system voltage value was back from error to normal, a recovered log should be
display when show logging (ex: System voltage has recovered to normal state)
Advertisement
Table of Contents
