Table of Contents
Advertisement
124. [IPv6] In ipv6 prefix, prefix in VLAN 1 should be consistent with prefix in VLAN 2.
125. [MIB-zyxelTrtcm] The zyTrtcmPortDscpProfile (OID: 1.3.6.1.4.1.890.1.15.3.85.1.3.1.4)
can't set any value via SNMPc or MIB Browser.
126. [MIB-zyxelSubnetBasedVlan] The zySubnetBasedVlanMaxNumberOfVlans (OID:
1.3.6.1.4.1.890.1.15.3.80.1.3) access-type should be "read-only", not "read-write".
127. [Firmware Upgrade] Ping device with ipv6 address will time out during firmware upgrade.
128. [MIB-zyxelTacacs] The zyTacacsAuthenticationServerIpAddress (OID:
1.3.6.1.4.1.890.1.15.3.83.1.1.3.1.2) can't set any value via SNMPc or MIB Browser.
129. [MIB-zyxelTacacs] The zyTacacsAccountingServerIpAddress (OID:
1.3.6.1.4.1.890.1.15.3.83.1.2.2.1.2) can't set any value via SNMPc or MIB Browser.
130. [WEB] The all port "Burst interval (seconds)" didn't work for ARP inspection port
configuration via WEB.
131. [IPv6] Enable ipv6 ND RA suppress, it should have "ND router advertisements
suppressed" information in show ipv6 VLAN.
132. [MIB-zyxelTransceiver] When using SilverCreek to test the zyxelTransceiverDdmiTable
(OID: 1.3.6.1.4.1.890.1.15.3.84.1.2), it will pop error message - "Agent returned
malformed instance ID for
ZYXEL-TRANSCEIVER-MIB:zyTransceiverDdmiDescription.25.5. Still has more
subidentifiers unmatched after ZYXEL-TRANSCEIVER-MIB:dot1dBasePort index. The
number of instance identifiers in the response OID does not match the index objects
defined for the table entry".
133. [MIB-zyxelTrtcm]The zyTrtcmMaxNumberOfDscpProfiles (OID:
1.3.6.1.4.1.890.1.15.3.85.1.4) for GS3700-24HP should be "29", not "53".
134. [LACP] testing interpretability on DLink and 3700-48HP, Synchronized Ports for device
3700-48 HP GUI should not be empty
135. [MIB-zyxelVlan] The zyVlanIngressCheckState (OID: 1.3.6.1.4.1.890.1.15.3.86.1.2)
access-type should be "notaccessible", not "read-write". And the table can be set via
SNMPc.
136. [MIB-zyxelVlanCounter] The zyVlanCounterPorts (OID: 1.3.6.1.4.1.890.1.15.3.87.1.1.1.3)
access-type is "read-write", but can't be set via SNMPc or MIB Browser.
137. [MIB-zyxelVlanMapping]When creating the max zyVlanMappingRowStatus (OID:
1.3.6.1.4.1.890.1.15.3.88.1.4.1.6) to one Port via MIB Browser, finding the Port value will
show "0".
138. [MIB-zyxelVlanStack] The zyVlanStackPortPriority (OID:
1.3.6.1.4.1.890.1.15.3.89.1.2.1.3) can't be set via SNMPc or MIB Browser.
139. [MIB-zyxelVrrp] The zyVrrpSecondaryVirtualIpAddress (OID:
1.3.6.1.4.1.890.1.15.3.91.1.2.1.8) can't set to default value.
140. [MIB-zyxelMacPinning] The zyMacPinningPortState (OID:
1.3.6.1.4.1.890.1.15.3.92.1.2.1.1) selected items should be "enabled/disabled",
not "inactived/actived".
141. [MIB-zyxelGreenEthernet] The zyGreenEthernetShortReachPortState (OID:
1.3.6.1.4.1.890.1.15.3.93.1.4.1.3) can't be set via SNMPc or MIB Browser.
142. [Static Route] Send port-pair L3 traffic via static route, only one direction can forward.
143. [POE] PoE port status (link and PoE status) should be correct when PD (NWA1300 NJ)
connected into the port
144. [Private VLAN] A private VLAN port can't be assigned to static VLAN.
145. [System] This CLI pop error message when restore IPSG configuration.
146. [MIB-ip]When setting the IPv6 in interface VLAN 1, the ipv6RouterAdvertIfIndex (OID:
1.3.6.1.2.1.4.39.1.1) will show "2".
147. [TRTCM] The trTCM rate is abnormal when 100M to 10M port.
148. [MIB-pingMIB] The pingCtlTargetAddress (OID:1.3.6.1.2.1.80.1.2.1.4) and
pingCtlSourceAddress (OID: 1.3.6.1.2.1.80.1.2.1.19) can't be set via SNMPc or MIB
Browser.
149. [MIB-pingMIB] The pingCtlTargetAddressType (OID: 1.3.6.1.2.1.80.1.2.1.3) and
pingCtlSourceAddressType (OID: 1.3.6.1.2.1.80.1.2.1.18) value should show "1(ipv4),
not "0(unknown)".
150. [Web Page] In XGS3700-48HP mode, Web display XGS4700 in left window.
151. [Broadcast Strom] Enable Broadcast storm to maximum value 33554431, then erase
running, CLI will pop error message.
152. [VRRP & Policy Route] Policy route doesn't work when use the VRRP It is a ITS issue.
Advertisement
Table of Contents
