Advanced Routing - TP-Link TL-WR802N User Manual

Chapter 4
6. Select Enable Internet Access Control
7. Select Allow the packets specified by any enabled access control policy to pass
through the Router
Done!
Now only the specific host(s) can visit the target(s) within the scheduled time period.
Note:
When LAN Host and Target
UDP, ICMP. The default setting is

4. 11. Advanced Routing

Static Routing is a form of routing that is configured manually by a network administrator
or a user by adding entries into a routing table. The manually-configured routing
information guides the router in forwarding data packets to the specific destination.
4. 11. 1. Static Route List
1. Visit http://tplinkwifi.net, and log in with the username and password you set for the
router.
2. Go to Advanced Routing
• To add static routing entries:
1. Click Add New.
2. Enter the following
as the default filter policy and click Save.
are both set to be the MAC Address mode, you need to set Protocol: ALL, TCP,
ALL and it is recommended to keep the default setting.
> Static Route
information.
Configure the Router in Wireless Router Mode
to enable Access Control function.
List.
44