TP-Link TL-WR802N User Manual page 79

Chapter 5
• MTU(Bytes) - The default MTU size is 1500 bytes. It is not recommended that you
change the default MTU size unless required by your ISP.
• Enable IGMP Proxy
multicasting on TCP/IP networks. Some ISPs use IGMP to perform remote configuration
for client devices, such as the modem router. The default value is enabled, and if you
are not sure, please contact your ISP or just leave it.
• Connection Mode
• Always On - In this mode, the internet connection will be active all the time.
• Connect on Demand
automatically after a specified inactivity period (Max Idle Time) and be re-
established when you attempt to access the internet again. If you want to keep
your internet connection active all the time, please enter 0 in the
field. Otherwise, enter the number of minutes you want to have elapsed before
your internet access disconnects.
• Connect Manually
immediately. This mode also supports the
on Demand
after a specified inactivity period (Max Idle Time) and not be able to re-establish
when you attempt to access the internet again.
5. 3. 2. LAN
1. Visit http://tplinkwifi.net, and log in with the username and password you set for the
router.
2. Go to Network > LAN.
3. Configure the IP parameters of the LAN and click Save.
• MAC Address - The physical address of the LAN ports. The value can not be changed.
• IP Address - Enter the IP address in dotted-decimal notation of your router (the default
one is 192.168.0.1).
- IGMP (Internet Group Management Protocol) is used to manage
- In this mode, the internet connection can be terminated
- You can click
mode. The internet connection can be disconnected automatically
Configure the Router in WISP Mode (Hotspot Mode)
Connect/Disconnect
Max Idle Time
Max Idle Time
to connect/disconnect
function as Connect
75