TP-Link TL-WR802N User Manual page 163

Chapter 7
Note:
If the web management port conflicts with the one used for
after the setting is saved.
• Allow a specific device to manage the router locally
1. Enter the IP or MAC address of the host that you want to manage the router in the
Available Host (IP/MAC)
(X is any hexadecimal digit).
2. If you want to access the router via both HTTPS and HTTP, please tick the
in HTTPS Service
3. Keep the Port as default if you don't know which port to use.
4. Click Save.
Note:
If your PC is blocked but you want to access the router again, press and hold the
factory defaults.
• Certificate
Download and install the certificate for management via HTTPS if you need it. Once the
certificate is installed, warnings will not pop up when you access the router via HTTPS.
7. 6. 8. System Log
1. Visit http://tplinkwifi.net, and log in with the username and password you set for the
router.
2. Go to System Tools
• Loge Type -By selecting the log type, only logs of this type will be shown.
• Log Level - By selecting the log level, only logs of this level will be shown.
• Refresh - Refresh the page to show the latest log list.
• Clear Log - All the logs will be deleted from the router permanently, not just from the
page.
entry. The format of the MAC address is XX:XX:XX:XX:XX:XX
column. Otherwise, keep it disbled.
> System Log, and you can view the logs of the router.
Configure the Router in Range Extender Mode
Virtual Server entry, the entry will be automatically disabled
Reset button to reset the router to the
Enable box
159