TP-Link TL-WR802N User Manual page 113

Chapter 5
• PPP Username/Password
your ISP. These fields are case-sensitive.
• Authentication Type
CHAP and MS-CHAP.
• Addressing Type
SLAAC (Stateless address auto-configuration) and DHCPv6 (Dynamic Host
Configuration Protocol for IPv6) Server.
• MTU(Bytes)
Ethernet networks is 1500 Bytes. For some ISPs, you may need to modify the
MTU. But this is rarely required, and should not be done unless you are sure it is
necessary for your ISP connection.
• Enable MLD Proxy
function if you need.
• Use IPv6 address specified by ISP
• Set IPv6 DNS Server manually
and secondary IPv6 DNS server.
Tunnel 6to4
• WAN Connection
5. 15. 3. IPv6 LAN
1. Visit http://tplinkwifi.net, and log in with the username and password you set for the
router.
2. Go to IPv6 > IPv6 LAN
- Enter the User Name and Password provided by
– Choose one authentication type from AUTO-AUTH, PAP,
- There are two types of assignation for IPv6 address:
- The normal MTU (Maximum Transmission Unit) value for most
- Enable the Multicast Listener Discovery (MLD) Proxy
- Enter the IP address of the IPv6 DNS server
- Display the available wan connection.
and configure the IPv6 LAN settings as needed.
Configure the Router in WISP Mode (Hotspot Mode)
- Input a static IPv6 address from the ISP.
109