Jacto ARBUS 1000 Operator's Manual page 32

Setting up the tractor
2
Adjusting the drawbar
• Fit the drawbar pin into the proper hole (1
or 2) to vary the distance between the PTO
shaft and the hitch point (see figure A).
NOTE:
For heavy load, the hole no. 2
is recommended (see figure A).
Table 1: Adjusting the drawbar
Hole
1
2
ATTENTION!
The figures shown in above table were obtained on a 63 HP tractor.
For explanation in detail, please consult the operator's manual of your tractor.
Adjusting the sprayer height and the tractor's drawbar
• Set the tractor's drawbar so as to allow
the sprayer to work on level after being
hitched (see figure B).
• Invert the drawbar to vary the height of
the hitching point (see figure C).
2-32
Distance between the PTO shaft
and the hitch point
14 in
10 in
ARBUS 1000
2
Maximum (static) load in lift
1,003.10 lb
1,300.72 lb
1