Introduction; Equipment; Control Panels; Technical Data - ESAB Caddy Tig 2200i AC/DC Instruction Manual

GB
2

INTRODUCTION

The Tig 2200i AC/DC is a TIG welding power source, which can also be used for
MMA welding. It can be used with alternating current (AC) or direct current (DC).
ESAB's accessories for the product can be found on page 97.
2.1

Equipment

The power source is supplied with a 5 m return cable, 3 m mains cable, carrying
strap, cable holder, shaft belt, instruction manual for power source and control panel.
2.2

Control panels

S
TA33 AC/DC
See the separate instruction manual for a detailed description of the control panels.
Instruction manuals in other languages can be downloaded from the website,
www.esab.com.
3

TECHNICAL DATA

Mains voltage
Mains supply
Primary current
I TIG
max
I MMA
max
No load power
demand when in the enery-saving mode,
6.5 min. after welding
Setting range
TIG AC* / DC
MMA
Permissible load at TIG AC/DC
20% duty cycle
60% duty cycle
100% duty cycle
Permissible load at MMA
30% duty cycle
60% duty cycle
100% duty cycle
bt33d1ea
S TA34 AC/DC
Tig 2200i AC/DC
230V, $10%, 1∼ 50/60 Hz
Z 0.28 ohm
max
27 A
25 A
40 W
3 - 220 A
4 - 160 A
220 A / 18.8 V
150 A / 16.0 V
140 A / 15.6 V
160 A / 26.4 V
120 A / 24.8 V
110 A / 24.4 V
- 86 -
© ESAB AB 2007