Overview Non Verifiable Weighing Systems (Contacts Of Circuit Board [K1] Not Short- Circuited) - KERN KFB-TM Service Manual

5.1 Overview non verifiable weighing systems
(contacts of circuit board [K1] not short-circuited)
Menu block
Main menu
PO CHK
Weighing with
tolerance range,
see chap. 7.7
P1 REF
Zero point
settings
P2 COM
Interface
parameter
KFB-TM/KFN-TM-SH-e-1410
Menu item
Available settings / explanation
Submenu
Upper limit value „Tolerance check weighing", input see
nEt H
chap. 7.7.1
Lower limit value „Tolerance check weighing", input see
nEt LO
chap. 7.7.1
Upper limit value „Tolerance check counting", input see
PCS H
chap. 7.7.2
Lower limit value „Tolerance check counting", input see
PCS L
chap. 7.7.2
BEEP no
ok
nG
A2n0 Automatic zero point correction (Autozero) by changing the
display, digits selectable (0.5d, 1d, 2d, 4d)
0AUto Zero setting range
Load range where the display after switching-on the
balance is set to zero.
Selectable 0, 2, 5, 10, 20, 30, 50, 100 %
0rAGE Zero setting range
Load range where the display is set to zero by pressing
. Selectable 0, 2, 4, 10 , 20* , 50, 100%.
Automatic taring „on / off", taring range adjustable in menu
0tArE
item „0Auto".
SPEEd Not documented
Zero Zero point setting
MODE
CONT
ST1
STC
PR1
Acoustic signal for weighing with tolerance range
switched off
Audio sound when load is within tolerance limits
Audio sound when load is beyond tolerance limits
S0 off Continuous data output,
selectable "send zero" yes / no
S0 on
One output for stable weighing value
Continuous data output of stable weighing
values
Output after pressing
- 10 -