Battery Operation; Connection Of Peripheral Devices; Initial Commissioning; Operation - KERN YKD Series Operating Instructions Manual

5.4 Battery operation

Lift-off the battery cover on the lower side of the appliance. Connect 9 V compound
battery. (not included in standard scope of delivery) Reinsert battery cover.

5.5 Connection of peripheral devices

Always disconnect the unit from the mains before connecting or disconnecting
peripheral devices (balance, printer) or the PC.
With your second display, only use accessories and peripheral devices by KERN, as
they are ideally tuned to your second display.

5.6 Initial Commissioning

Go to the menu of the connected balance and set the parameter PR to rECr and
the baud rate at 9600 baud.
For details please see operating instructions for the connected balance.
Plug one end of the supplied interface cable into the balance and the other end into
the right side of the case of the second display unit.

6 Operation

6.1 Overview of display

6.2 Display

Turn on appliance by pressing the ON/OFF key.
Unit displays "88888" for approximately 3 seconds. Afterwards the display of the
connected balance will be imported. Now it is ready for operation.
"ON" will be displayed if the connected balance does not send a signal or is not
connected correctly.
8 YKD-BA-e-0710