Installation - KERN KFB-TM Service Manual

In this lineup it is an eco product, Therefore, it is not intended to represent the repair manual in detail,
since the construction of the balance is very simple. It is therefore only referring to the list of related to
disposal spare parts.

3 INSTALLATION

Precautions









3.1 Installation

Place the Indicator on a table or connect with proper stand.

Connect the plat form load cell cable in to the indicator load cell connecter. Load cell
connecter is locating back side of the indicator.

Connect the adaptor pin in to the indicator adaptor jack.
Adaptor jack is locating, back side of the indicator.

Adaptor connects into your AC power socket.
equipment must be installed near an easily accessible socket outlet with a protective
ground/ earth contact.

Turn on the On/Off key. If you want to turn off, press the key again.

Display will be show the scale capacity and will be starting self checking.

After self checking, display will be come to normal weighing mode.

Warm-up time of 15 minutes stabilizes the measured values after switching on.

Calibrate with exact calibration weights, minimum 1/3 of the scale capacity want to
use for calibration. For calibration see details in parameter.
KFB-TM/KFN-TM-SH-e-1410
The weighing indicator is a precision electronic instrument, handle it
carefully.
Do not install the scale in direct sunlight.
Verify the local voltage and receptacle type are correct for
the scale.
Only use original adaptor, other could cause damage to the scale.
Pluggable equipment must be installed near an easily accessible
socket outlet.
Avoid unstable power sources. Do not use near large users of
electricity such as welding equipment or large motors.
Avoid sudden temperature changes, vibration, wind and water.
Avoid heavy RF noise.
Keep the indicator clean.
Pluggable
- 4 -