Accessing The Middle Compartment On The Control Panel; Electrostatic Discharge Damage - Kohler APM802 Installation Instructions Manual

Disabling the generator set.
cause severe injury or death.
generator set or equipment connected to the set, disable the
generator set as follows: (1) If the controller is not already in
the MAN (manual) mode, press the Controller Mode button
and then press the MAN mode button. (2) If the generator set
is running, press and hold the Manual--Stop button for at least
2 seconds to stop the generator set. (3) Press the Controller
Mode button and then press the controller Off mode button.
(4) Disconnect the power to the battery charger, if equipped.
(5) Remove the battery cables, negative (--) lead first.
Reconnect the negative (--) lead last when reconnecting the
battery. Follow these precautions to prevent the starting of the
generator set by the remote start/stop switch.
(Decision-Makerr 8000 Controller)
CAUTION
Hot surfaces.
(APM802 Controller Heater)
TT-1625 7/17
Accidental starting can
Before working on the
DANGER
Hazardous voltage.
Will cause severe injury or death.
This equipment must be installed and
serviced by
personnel.
DANGER
Hazardous voltage.
Will cause severe injury or death.
Disconnect all power sources before
opening the enclosure.

Accessing the middle compartment on the control panel.

Hazardous voltage can cause severe injury or death. On
the controller base box and automatic voltage regulator, do not
touch the terminals for voltage and current measurement.
Disconnect all power sources and disable the generator set
before servicing.
(Decision-Makerr 8000 Controller)
NOTICE
Electrostatic discharge damage. Electrostatic discharge
(ESD) damages electronic circuit boards.
electrostatic discharge damage by wearing an approved
grounding wrist strap when handling electronic circuit boards
or integrated circuits. An approved grounding wrist strap
provides a high resistance (about 1 megohm), not a direct
short, to ground.
qualified electrical
Prevent
9