Table of Contents
Advertisement
8. INSTALLING THE FUEL BED COMPONENTS
Figure 10. Ceramic Base Location
Figure 11. Front Coal Location
INSTALLER'S GUIDE
brackets. (See figure 10).
(Installer - Note that the small round holes
in the burner plaques that will be covered by
the base coal are not gas burner ports. They
are simply a consequence of the plaque
manufacturing process).
2.
in position in front of the base coal (See
figure 11).
3.
in position in front of the base coal. This
should overlap the left-hand coal. Push the
two sides together to minimise the gap. (See
figure 11).
4.
of the front coals and the front of the base
coal. (See figure 11).
Page 18
8.1 This section is for
models supplied with a
'Coal' effect fuel bed
only.
For 'Pebbles' see section
8.2
1.
Place the ceramic
base coal in the burner
compartment. The bottom
rear face of the coal should
rest against the angled
ledge at the back of the
burner tray. The coal does
not rest on top of the
angled ledge. The bottom
front edges of the coal base
should locate against the
left and right hand side
Place the left-hand ceramic front coal
Place the right hand ceramic front coal
There will be a gap between the rear
Advertisement
Table of Contents
