Short List Of Spares - Valor 639 Installer's Manual

• Place the new left hand plaque in position. The left side of the plaque must touch the
inside edge of the retaining flange at the left side of the burner well.
• Place the new right hand plaque in position. Make sure that the centre section of the
combination gasket is between the two plaques. If there is any play between the plaques
and the end retaining flanges, push the plaques firmly to the left squeezing the centre
section of the combination gasket between the two plaques. Any gap should be between
the right side of the plaque and the right side-retaining flange.
• Fit the front and rear plaque clamping strips. Make sure that the plaques are as far to the
left as possible. . It is important that the left side plaque is accurately positioned so
that it has the correct relationship to the pilot. Fully tighten the clamping strips.
• Refit the coals/ Pebbles as described in section 8 of this guide. Refit the decorative
firefront.
DESCRIPTION
Pilot unit
Burner injector
Burner plaque & gasket set
Gas tap
(Models with 'Coal' fuel
effect bed)
Coal matrix
Front coal Set
Pack of 12 loose coals
(Models with 'Pebble' fuel
effect bed)
Pebble matrix
Front Pebble set
Pack of 16 loose pebbles
Because our policy is one of constant development and improvement, details may vary
© Valor Heating
INSTALLER'S GUIDE

12. SHORT LIST OF SPARES

NO.
OFF
1
1
1
1
1
1
1
1
1
1
slightly from those given in this publication.
Page 37
MAKER'S PART NO.
MODEL
639 (Nat. Gas)
720A249
720A072
000A913
3002368
3002190
3002330
3002193
3002448
3002516
3002442
639 (Propane)
720A300
3002350
000A931
3002368
3002190
3002330
3002193
3002448
3002516
3002442