1.
Lift the exposure glass cover or the ADF.
Be sure to lift the exposure glass cover or the ADF by more than 30 degrees. Otherwise, the size of
the original might not be detected correctly.
2.
Place the original face down on the exposure glass. The original should be aligned to the
rear left corner.
Start with the first page to be copied.
1. Positioning mark
2. Scales
3.
Lower the exposure glass cover or the ADF.
• When you lower the exposure glass cover or the ADF, an indicator will light to show you that the
machine is detecting the size of the original.
Placing Originals in the ADF
Place originals in the ADF.
Be sure not to block the sensor or load the original untidily. Doing so may cause the machine to detect the
size of the original incorrectly or display a paper misfeed message. Also, be sure not to place originals or
other objects on the top cover. Doing so may cause a malfunction.
BCU011S
Placing Originals
1
23