Placing Originals In The Adf - Ricoh MP 2001 Operating Instructions Manual

2. Placing Originals
• Be sure to lift the exposure glass cover or ADF by more than 30°. Otherwise, the size of the
original might not be detected correctly.
2. Place the original face down on the exposure glass. It should be aligned with the rear left
corner.
1 1
2 2
1. Positioning mark
2. Left scale
• Start with the first page to be copied.
3. Lower the exposure glass cover or ADF.
• For details about how to specify the size of the originals, see page 39 "Specifying the Original
Size When a Paper Tray is Selected" or page 42 "Specifying the Original Size When the Bypass
Tray is Selected".

Placing Originals in the ADF

Settings should be made in the following situations:
• Do not stack originals over the limit mark on the side fence of the ADF.
• The last page should be on the bottom.
• Do not cover the sensors with your hands, or place objects on them. Doing so could cause the size
to be detected incorrectly, or the paper misfeed error message to appear. Also, do not place
anything on the cover, as this too could cause a malfunction.
38
CUA105