Telnet Control - Lindy 38266 User Manual

Manual

TELNET CONTROL

Please refer to the following Telnet command list to setup your configuration through an IP or Serial RS-
232 connection.
GENERAL COMMANDS - Valid for both the Transmitter (No.38266) and Receiver (No.38267) unit
COMMAND
CLASS
HELP
NETWORK
NETWORK
SYSTEM
COMMAND SINTAX
HELP
HELP N1
GET_IPCONFIG
SET_IP_MODE N1
GET_IP_MODE
SET_IP_ADDRESS N1
GET_IP_ADDRESS
SET_NETMASK N1
SET_NETMASK N1
GET_NETMASK
SET_GATEWAY N1
GET_GATEWAY
SET_JUMBO_MTU N1
GET_JUMBO_MTU
GET_HARDWARE_VERSION
FACTORY_RESET N1
REBOOT
Show the full command list.
Show help details about command N1.
N1 = {Any command name}
Show the current IP configuration.
Set the IP configuration mode.
Available values for N1:
0 [Static IP Mode]
1 [DHCP Mode]
2 [Auto IP Mode].
Show the current IP configuration mode.
Set the static IP address.
N1 = X.X.X.X
Show the current IP address
Set the Ethernet netmask.
N1 = X.X.X.X
Set the Ethernet netmask.
N1 = X.X.X.X
Show the current Ethernet netmask.
Set the IP gateway address.
N1 = X.X.X.X
Show the current gateway address.
Enable/disable the jumbo frame MTU.
Available values for N1:
0 [Disabled]
1 [Enabled]
Show the jumbo frame MTU state.
Show the current hardware version.
Perform a factory reset on the unit
and select the IP mode after the
0 [Reset into Static IP mode]
1 [Reset into Auto IP mode]
20
English
DESCRIPTION
[X = 0~255]
[X = 0~255]
[X = 0~255]
[X = 0~255]
reset completes.
Available values for N1:
Reboot the unit.