Lindy 38266 User Manual page 18

Manual English
group. The Video Wall tab is accessible on both Transmitters and Receivers, however video wall settings may only
be applied to Receiver units.
When saving changes on the Video Wall tab, remember to select the appropriate "Apply To:" target unit before
pressing the "Apply" button. To make changes to the unit you are currently connected to, select "This" as the target.
Otherwise, select the IP address of the Receiver (Client) you want to apply changes to from the "Apply To:" drop
down.
Notes:
While it is possible to create small video walls using unicast mode, in order to more efficiently use the available
network bandwidth, it is strongly recommended to only use multicast mode when creating video walls.
The Video Wall tab is optional, and will not show up in the WebGUI tab list unless the "Enable Video Wall" checkbox
on the Functions tab is checked.
•
Bezel and Gap Compensation
This section of the Video Wall tab is used to define the physical dimensions of each display being used in the video
wall. Accurate measurements are needed of the monitor's outer frame (OW, OH) and the video screen (VW, VH).
The measurements may be made using any unit of measurement (inches, mm, cm, etc.) as long as ALL
measurements in the same wall are made using the exact same units and the numbers are integers.
- OW (Outer Width): This is the horizontal measurement of the displays outer case.
15