Lindy 38266 User Manual page 15

Manual
•
Video over IP
This section allows control over many critical functions of the Transmitter including: selection of the input source,
enabling/disabling the VoIP stream, enabling access to the Video Wall tab, and controlling the streaming bit rate and
quality.
- HDMI/VGA: Switch between the HDMI or VGA input on the Transmitter.
- Enable Video over IP: Unchecking this checkbox will disable the VoIP stream completely. This option should
always remain checked unless troubleshooting is being performed.
- Enable Video Wall: Checking this box will enable the Video Wall tab in the WebGUI.
Note: It is not required to enable this on the Transmitter to set up a video wall. Only Receiver units require this to be
enabled.
- Maximum Bit Rate: Set the maximum bit rate that can be used by a single video stream. Available options
are: Unlimited, 400 Mbps, 200 Mbps, 100 Mbps, 50 Mbps. Selecting "Unlimited" will use up to the maximum available
bandwidth in order to maintain a full framerate video stream.
Note: While it is generally suggested to select "Unlimited" when streaming 4K video sources, the amount of bandwidth
required can be very large and will limit the number of concurrent video streams.
- Maximum Framerate: Adjusting this slider will set the percentage of frames from the source video to encode (2–
100%). This is ideal for reducing the bandwidth requirements of high-resolution, but limited motion, sources such as
power point presentations or information screens.
Note: If the framerate is lowered too far with motion video sources, the video will become noticeably choppy.
•
USB over IP
This section provides controls for the USB over IP extension functionality, including enabling/disabling USB support,
changing the USB operational mode, and enabling special compatibility modes.
- Enable USB over IP: Unchecking this checkbox will completely disable support for USB over this stream.
This option should generally remain checked, but, if USB support is not required, disabling this feature can save
some bandwidth.
- Operation Mode: Sets the USB extension mode. Available options are Auto, Active on link (Unicast
optimized), and Active per request (Multicast optimized). Auto mode is set by default and will automatically select the
correct mode depending on the broadcast mode of the unit.
- Compatibility Mode: These troubleshooting options enable specialized optimizations to solve issues when a
mouse or touch panel is not responding properly. They should normally be left unchecked.
•
Serial over IP
This section provides controls for the Serial over IP extension functionality, including enabling/disabling Serial support
and setting the RS-232 data configuration.
- Enable Serial over IP: Unchecking this checkbox will completely disable support for sending RS-232
commands over this stream. This option should generally remain checked, but, if serial support is not required,
disabling this feature can save a very small amount of bandwidth.
- Serial Settings: Set the desired baud rate, data bits, parity, and stop bit for the RS-232 signal to extend.
Note: The Transmitter and Receiver must have the same serial settings.
12
English