Table of Contents
Advertisement
Manual
Allows for the selection of the broadcasting mode used by the Transmitter. Click the "Apply" button to save changes
made to the broadcasting mode.
Note: Receivers must be set to the same mode as the Transmitter in order to receive video.
-
Multicast: This mode sends a single video stream that can be viewed simultaneously by multiple receivers
without increasing bandwidth usage. This mode is ideal for video wall or matrixing scenarios. Multicast mode requires
a network switch with IGMP snooping enabled.
Note: The 3 port network switch built into the Receiver units supports IGMP snooping and may be used to distribute
a multicast stream.
-
Unicast: This mode uses a discrete video stream for every connected Receiver and is ideal for simple, point-
to-point, streaming setups. This mode uses considerably more bandwidth than Multicast mode when multiple
Receivers are being used, however it does not require a network switch that supports IGMP snooping.
Functions Tab
The Functions tab provides control over the Transmitter's video source selection, streaming bandwidth/quality
settings, as well as a wide variety of optional features and functions, including USB and Serial control extension.
Changes made to these settings typically require a reboot of the unit. After clicking on "Apply" please follow the reboot
instructions in the WebGUI, if necessary.
11
English
Advertisement
Table of Contents
